Replacing cable slide

Discussion in 'Parker Crossbows' started by Bobo, Jul 26, 2011.

  1. Bobo

    Bobo New Member

    Messages:
    56
    Likes Received:
    3
    I need to replace my cable slide on the Cyclone and have a couple of questions.

    Do I purchase this from Parker? and do I have to press the bow to replace?

    Thanks
     
  2. harrisdj

    harrisdj New Member

    Messages:
    41
    Likes Received:
    6
    I would be glad to send you a slide for your crossbow. If you would email me your address to dough@parkerbows.com. I will send you one.You can then go to our website at Parkerbows.com and look at the how to video. This will help you in installing your slide. Thanks and I will look forward to helping anyway I can..... Doug Harris Parker Bows.
     
  3. Bobo

    Bobo New Member

    Messages:
    56
    Likes Received:
    3
    Now that right there is customer service my friends. This is one of the reasons I told my wife I wanted A Parker For Christmas last year.
     
  4. PHS1990

    PHS1990 Member

    Messages:
    91
    Likes Received:
    1

    Great! I just had a replacement slide sent to me. I am glad there is a how to video on replacing it. Thanks for the great service!

    PHS1990
     
  5. PHS1990

    PHS1990 Member

    Messages:
    91
    Likes Received:
    1

    Doug,

    I just went to the Parker site to see how to replace the slide and I did not see where the video was. Can you post the link?

    Thanks,

    PHS1990
     
  6. Cossack

    Cossack Incurable Tinkerer

    Messages:
    4,495
    Likes Received:
    2,044
    Location:
    No MN
    Only referance to replacing the cable slide is under the troubleshooting section re cable wear. (A safe/strong press to do the job and know what you're doing necessary). Instructuons are to take it to a dealer.
     
  7. robertyb

    robertyb Active Member

    Messages:
    1,047
    Likes Received:
    546
    Location:
    Georgia
    I checked it out and it does not show how under the Cyclone video. It does show the cable slide assembly on the Buckbuster video though I would think they are very similar it not exactally the same assembly.

    http://www.youtube.com/watch?v=AP-gg82Sh5I
     
  8. Buck Buster

    Buck Buster Flying Dutchman

    Messages:
    1,458
    Likes Received:
    33
    Thank you for the video, i had a problem with my cable slide last year. Parker sent me new one. Thanks Parker!
     
  9. KodiakIslandArchery

    KodiakIslandArchery Senior Member

    Messages:
    342
    Likes Received:
    3
    Location:
    Fairbanks, Alaska
    I need some cable slides...sent teamparker (doug) a email plus a message on here, don't know if he will get it, he has not been on here for awhile
     
  10. oldhoosier

    oldhoosier Member

    Messages:
    208
    Likes Received:
    69
    Location:
    JASPER COUNTY, INDIANA
    I didn't need a press to install the cable slide and front bow on my Parker Hornet Extreme. The important thing is to cross the cables, on the left side of the stock while in the shooting position, in the right direction.
     

Share This Page