Measured my tiller on my Cyclone today and one side was off by 1/16". Is this enough to be concerned about? If so how do I correct it. Do I twist cables or loosen a limb bolt?
0
3 replies to this topic
#1
rongcp
-
- Members
- 14 posts
Member
Posted 25 December 2011 - 09:07 PM
2011 Parker Cyclone
2010 Parker Tornado
2010 Parker Tornado
#2
Zrt1200
-
- Members
- 826 posts
Senior Member
- LocationMId Michigan
Posted 25 December 2011 - 10:54 PM
1/16th of a inch is not enough to worry about at all. Are you having a problem??
Bowtech SZ380 w/ XB30 Scope 2011Team, Old Farts Venison Club.
Parker Tornado w/ Hawke SR Scope 2010 team, The Rack Pack
MCF member NRA member 300 Magnum For the Long shots!!
Parker Tornado w/ Hawke SR Scope 2010 team, The Rack Pack
MCF member NRA member 300 Magnum For the Long shots!!
#3
rongcp
-
- Members
- 14 posts
Member
Posted 29 December 2011 - 05:45 PM
Zrt1200, on 25 December 2011 - 10:54 PM, said:
1/16th of a inch is not enough to worry about at all. Are you having a problem??
2011 Parker Cyclone
2010 Parker Tornado
2010 Parker Tornado
#4
pa crossbow
-
- Members
- 828 posts
Senior Member
Posted 29 December 2011 - 07:17 PM
Just a thought check both limb bolts to see that they are tightened equally.Could possibly be the difference.
Team Backstrap Assasins
Pennsylvania Crossbow Federation
American Crossbow Federation
Michigan Crossbow Federation
NRA Life Member
Pennsylvania Crossbow Federation
American Crossbow Federation
Michigan Crossbow Federation
NRA Life Member
