Crossbow Nation banner
1 - 9 of 9 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter · #1 ·
Know this is a long shot. I own a 2010 Wicked Ridge Invader. I need to know: Axle to axle:
A. Strung but NOT Cocked
B. Cocked
Also need: Brace Height
How do you measure brace height on a crossbow??
THANKS Ray
 

·
Registered
Joined
·
7,197 Posts
Know this is a long shot. I own a 2010 Wicked Ridge Invader. I need to know: Axle to axle:
A. Strung but NOT Cocked
B. Cocked
Also need: Brace Height
How do you measure brace height on a crossbow??
THANKS Ray
Email: [email protected]
He is the Ten Point representative that shows up on the Ten Point forum.

Wishing you all the best.
Take care.
 

·
Registered
Joined
·
81 Posts
Discussion Starter · #4 ·
Know this is a long shot. I own a 2010 Wicked Ridge Invader. I need to know: Axle to axle:
A. Strung but NOT Cocked
B. Cocked
Also need: Brace Height
How do you measure brace height on a crossbow??
THANKS Ray
Thought I would try this one more time. I need these measurements to monitor and check my bow. I even had one person on another site to tell me he would send me the measurements but nothing yet and this was some time ago. THANKS!!
 

·
Registered
Joined
·
5 Posts
Sorry for the delay, I was out of the office the back part of last week.
26.5 axle to axle uncocked. 4.5 inch brace height.
Thank You Very Much for previous replies? One more Q., Please?
How do I measure Brace Height on a crossbow./ I own a 2010 Wicked ridge Invader and have harvested 3 deer with it.
 

·
TenPoint Representative
Joined
·
2,560 Posts
Thank You Very Much for previous replies? One more Q., Please?
How do I measure Brace Height on a crossbow./ I own a 2010 Wicked ridge Invader and have harvested 3 deer with it.
We don’t really use that measurement, but it would be from the limb, right by the pocket, to the string.
 
1 - 9 of 9 Posts
Top