Cam timing dot on nemesis 180

794 Views 3 Replies 2 Participants Last post by Bryanb, Dec 23, 2019

Bryanb

Discussion Starter · Dec 23, 2019

I am syncing my cams and was seeing if someone knows what the measurement from limb to center of hole is. Thanks

Save

1 - 4 of 4 Posts

Bryanb

Discussion Starter · #2 · Dec 23, 2019

Nemesis 480 sorry

Bryanb said:
I am syncing my cams and was seeing if someone knows what the measurement from limb to center of hole is. Thanks

Save

I had asked Rex that when I got my 480 and he didn't tell me a number,but he did say to look at the cut out in the cam closest to the timing dot and when the inner edge of it is flush with the inside of the limb,it's good.

Save

Bryanb

Discussion Starter · #4 · Dec 23, 2019

Tnmtns said:
I had asked Rex that when I got my 480 and he didn't tell me a number,but he did say to look at the cut out in the cam closest to the timing dot and when the inner edge of it is flush with the inside of the limb,it's good.

Thanks buddy.

Save

1 - 4 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month