Crossbow Nation banner

1 - 4 of 4 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
I've got a centerpoint specialist 370 I've had about a year. It's been pretty on but I had gotten a dozen BEA Zombie slayers and 4 shot poorly.

So I've been pursuing finer accuracy and am presently building a spine indexing tool(almost done) and decided to tune my cams a bit. I used the screwdrive method, they had quite a bit of lean. I was able to get them almost perfectly straight in a few minutes and also evened out the tiny difference in distance between the axle length from center. They seem to be in time so I'm not worried about that.

I took the bow shooting immediately after making these changes and wow, after I made some minor adjustments in the scope it was dead on. The strangest thing is the arrows I had culled were now shooting just as good if not better than the ones I had been considering good! I kinda supect those arrows are a little off but the cam lean etc may have been exacerbating their issues.

I'm really looking forward to getting my arrows all spine indexed to see what that does. The difference in my bow with the cam lean fixed is noticeable, even my fiance noticed it seemed to be shooting better.
 

·
Registered
Joined
·
6,632 Posts
So you were able to lock the cams out on the CPSniper 370 Specialist with the screw drivers through the cams meathod without causing any damage to the limbs, cams, cam axles ?

Edit: ps, Frank Zappa for president ?....lol
 

·
Registered
Joined
·
25 Posts
What spine index tool are you building, I was talking to my brother about that this last weekend

Sent from my Pixel 4 using Tapatalk
 

·
Registered
Joined
·
13 Posts
Discussion Starter #4
So you were able to lock the cams out on the CPSniper 370 Specialist with the screw drivers through the cams meathod without causing any damage to the limbs, cams, cam axles ?

Edit: ps, Frank Zappa for president ?....lol
Yea it was pretty easy and didn't cause any damage as far as I could tell. I shot it like 50+ times right after and no issues. I want to make a press at some point but it's not in the cards right now.
 
1 - 4 of 4 Posts
Top