Crossbow Nation banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I made a cheek riser for my Micro so that I had better scope alignment , it raised my cheek weld about an inch. I'm sure it'll work on other makes of crossbows.
I used and piece of 1 1/4" pvc pipe approx. 5 inches long, i then split the pipe lengthwise. I used a heat gun and heated one side of the split pipe and softened the pipe so it could be straightened out, I used a vise to help with the process by forming a flat section . Once the straightened out section had cooled I positioned the piece for the best alignment for the scope. I used stainless steel counter sink screws to attach the cheek riser to the stock. I tapped the hole in the pvc to accept the countersink screws.
here are a few pics of the project.




 
1 - 4 of 4 Posts
Top