Crossbow Nation banner
1 - 4 of 4 Posts

Senior Member
14,074 Posts
Discussion Starter · #4 ·
I had to modify the Weaver base rail

as it was too low to allow the Accudraw Horseshoe to slide underneath it. I also had to step it to allow removal of the horseshoe from the bowstring after cocking. It was a little more work than I intended but turned out nicely. I first thought about modifyig the Accudraw horseshoe but decided to make the changes on the scope rail instead.


1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.