Crossbow Nation banner

1 - 1 of 1 Posts

·
Banned
Joined
·
5,180 Posts
Discussion Starter #1
I ordered 4 aluminum bars 3/4” x 1 1/4” x 5” and hopefully I can make them into fingers for my R10. I have to drill 1/2” holes so they’ll lay snug on the bottom of this “strut” that I have my regular press fingers on.

My BIL has a 5/8” end mill that should make the half rounds on the ends that will press against the axle posts on the limb ends. Hopefully I can keep the tolerance exact, otherwise I'll have to buy a Ravin press. :unsure:


Bow Press 010.jpg
DSCN2736.JPG
 
1 - 1 of 1 Posts
Top