Crossbow Nation banner
1 - 10 of 10 Posts

·
Registered
Joined
·
2,660 Posts
Discussion Starter · #1 ·
I was inquiring about a better way to pull arrows out of my Reinhardt Targets and the Blob. After getting some advice from Bunny, I rigged up this contraption. Works very well.
What better about this than the DD that I own is you can you 2 hands. Cost ($12) was a new 9 inch irwin needle nose vise grip and 5 minutes
Pliers Tool Wire stripper Cutting tool Lineman's pliers
Pliers Wheel Bolt cutter Cutting tool Rim
Bicycle part Tire Bicycle drivetrain part Bicycle wheel Bicycle chain
of welding. Instead of the file handles that Bunny used I welded 1/2 rebar and put gas hose over it.
 

·
Registered
Excalibur Vortex 330, Centerpoint Sniper 370, Centerpoint Patriot 425
Joined
·
16,877 Posts
Looks good....and workable too.:)
 
  • Like
Reactions: bunnyrabbit

·
Registered
Joined
·
2,483 Posts
What size and type pipe and hose did you use for the arrow puller? I just ordered a blob target and thought I would try to fab an arrow puller before it arrives. I like the one Bunny made too.
 

·
Registered
Joined
·
75 Posts

·
Senior Member
Joined
·
14,494 Posts
I don't ... pull arrows. I pick them up covered with blood.:p;)
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top