Crossbow Nation banner

1 - 14 of 14 Posts

·
Registered
Joined
·
66 Posts
Discussion Starter #1
can a ravin jackplate fit the barnett scope rail?,similar to the hha optimizer ,I see the optimizer is less money ,and both seem to do the same thing
Screenshot_20200105-031542_eBay.jpg
 

·
Registered
Joined
·
4,682 Posts
If the Ravin Jack Plate would work, the advantage is the dial is under the scope. The disadvantage is it may raise the scope higher.

The HHA dial is on the right hand side as one holds the crossbow in the shooting position. For anyone using the Barnett Crank Cocking Device with the handle on the right hand side, one has to allow room for the handle to turn and finger clearance.
I have two Barnett Ghost 410 crossbows set up with the HHA and all the crossbows have the Barnett Crank Cocking Device with the crank on the right hand side.

Both these products, when making an adjustment (rotating the dial) for longer range shooting, tilt the front of the scope downward which forces the shooter to tilt the front of the crossbow upwards.

All the best.
 

·
Registered
Joined
·
5,653 Posts
I can't speak for the RJP but the HHA Optimizer is quite accurate for either a scope or a red dot sight on the Barnett Scope rail (TS370 and TS390). I would think the the Ravin Jack Plate would work great if you desire that design. I would think it would fit on the rail without issue.

Good luck!
 
  • Like
Reactions: dear/slayer

·
Registered
Joined
·
498 Posts
I can't speak for the RJP but the HHA Optimizer is quite accurate for either a scope or a red dot sight on the Barnett Scope rail (TS370 and TS390). I would think the the Ravin Jack Plate would work great if you desire that design. I would think it would fit on the rail without issue.

Good luck!
Yes this isn't a WR Rdx if you know what I mean, Is that a dig lol ...KT
 

·
Registered
Joined
·
5,653 Posts
sorry I dont understand your abbreviation, can you elaborate
WR RDX is Wicked Ridge reverse draw scope rail is very narrow and many scopes will not secure properly. That is true I had one.
 

·
Registered
Joined
·
5,653 Posts
Freaken strange how they did that and why ....smh
Duly noted and no hate but that was a head scratcher why they would use a non standard scope rail. I had to add electric tape to shim the width so today's scopes would securely attach to the scope rail. All good and rear view mirror.

Oh, yes, this is a safe haven for Barnett owners for those are in need of support.
 

·
Registered
Joined
·
5,653 Posts

·
Registered
Joined
·
66 Posts
Discussion Starter #14
Wow, so you disassembled your Xbow and dipped or painted it? IF so impressive. Ddi you do this or paid to have it done?
just a rattle can ,but the pic shows the ar style butt stock I modified and chopped the raptor w sawzall,now it has a worker mod nerf toy ,stock,that folds,extends and is quik detatch, and is very light,some j.b. weld was used and some fitting,but turned out good,fits in my pack,and assembles quickly,
 
1 - 14 of 14 Posts
Top