Crossbow Nation banner

1 - 1 of 1 Posts

·
Premium Member
Joined
·
1,300 Posts
Discussion Starter #1 (Edited)
Finally got around to picking up some foam pipe insulation that measures about 1-5/8" O.D. and 3/4" I.D.
Cut a piece about 4 inches long or so, just enough to fit inside the Grip.

20200923_182200.jpg

As you can see in the original setup, the second joint of my index trigger sits naturally on the trigger.

20200923_182107.jpg

After installing the insulation, the first joint is just about in perfect position.

20200923_182340.jpg

All I did was wrap it around as is, did not tape it or anything.
Feels pretty good and I'm sure with a few tweaks, should be good to go for a long time.

If your hand is too large for the grip to trigger length, you may want to give this a try.
It doesn't look the greatest but I don't think a target, deer or whatever you may be shooting at really gives a hoot about it's looks.

20200923_182248.jpg

:)

Will try it out this weekend.
Best part is, it is easy to remove for the Wife and younger Children to use as originally intended.
Thanks again to Member idock for the suggestion!
Cheers,
dynamo61
 
1 - 1 of 1 Posts
Top