What distance are your Deathstalker timing holes from the limbs?

1132 Views 4 Replies 3 Participants Last post by tpcollins, Jan 7, 2020

tpcollins

Discussion Starter · Jan 5, 2020

I have the Scorpyd supplied Rogue string and cables on my DS (waiting for a new set from Marty).

Prior to last year’s season, I had the cams pretty much in sync - but not sure where the exact timing should be though.

I’ve shot the DS numerous times since and it’s been hanging in the case in my storage room, so today I measured the timing holes.

Left cam - 3/8” from limb to center of hole

Right cam - a fat 5/16” from limb to center of hole

I’ll get them set dead nuts the same when I install the new set but what distance is considered "Scorpyd’s spec” distance? Thanks.

.

Save

1 - 5 of 5 Posts

robertyb

· #2 · Jan 5, 2020

I don't think they have ever told us that. They only mention cocked ATA.

Save

tpcollins

Discussion Starter · #3 · Jan 5, 2020

Robert - I was asking what distance the existing “DS owners” have - I know Scorpyd doesn't list it.

I thought you owned a GS or GR, what’s your distance?
.

Save

dryforkbrady

· #4 · Jan 5, 2020

Limb to hole center...5/16" R&L. Course measurement with metal tape.

Save

tpcollins

Discussion Starter · #5 · Jan 7, 2020

dryforkbrady said:
Limb to hole center...5/16" R&L. Course measurement with metal tape.

Thanks Dryfork, I guess I’m close then.
.

Save

1 - 5 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month