Crossbow Nation banner

Wyvern's Dragon Claw Arrows

8148 Views 15 Replies 11 Participants Last post by  TBrom
Anyone shooting Wyvern's arrows? It's a BEE that comes in at 345 grains with a lower profile vane than some of the other popular arrows. Shooting great for us at top end speeds. Just curious if anyone here is killing anything with them?
Font
See less See more
  • Like
Reactions: 1
1 - 16 of 16 Posts
Todd I'm shooting them out of my nitro x they shot good with the 2 inch cut swacker.i killed this with them last Saturday at 50 yards.
Canidae Coyote Carnivore Deer
See less See more
  • Like
Reactions: 5
Shot them out of my assassin . Work great


Sent from my iPhone using Tapatalk
  • Like
Reactions: 4
3
Yep. I got a dozen bare shafts from Dave in early 2019. Bare shaft tested and sorted them. Fletched them with offset, 3” fusions. They will put Ramcats right with field points out to 50. This arrow was hanging out of the exit side when the buck was thrashing around in hard rock. Still fine other than a few scratches.

Tree Plant
Bow and arrow Bow Compound bow Deer Hunting
Wood Table Furniture Metal Bench
See less See more
  • Like
Reactions: 4
Gotta love a nice bloody arrow! :)
  • Like
Reactions: 4
I have them and they shoot great.
  • Like
Reactions: 2
Yep. I got a dozen bare shafts from Dave in early 2019. Bare shaft tested and sorted them.
Joe - at what distance do you bare shaft test them and how much did you rotate each shaft to find the sweet spot? I assume you started with either spine up or spine down. Thanks.
.
  • Like
Reactions: 1
Tim, I shot the bare shafts at 30 yards. I marked them much like Randy XX75 did on C/T, but every 45 degrees. When they shot into my aiming spot 3 times in a row. I marked the top of the arrow much like I've seen spine indexed arrows marked. After that, I fletched them. Excalibur bow and flat nocks.
  • Like
Reactions: 3
They fall rite in with my tapps..zombies..aerobolts... Excaliburs shoot them good
  • Like
Reactions: 2
Good info and great kills guys. They're flying great for us as well out of any setup we throw them at. Thank you!
  • Like
Reactions: 2
I love when people start tuning arrows. Always room for improvement.
345gr … with or without a field point?
  • Like
Reactions: 1
345gr … with or without a field point?
Mine are 18”, 110 gr inserts, 100 gr point, plastic flat nock, 3” fusion vanes. 414 grains, if that helps.
  • Like
Reactions: 2
345gr … with or without a field point?
20" arrow without field tip. I'm wanting to get to a 500 grain (minimum) total weight arrow.

Arrow Metal
See less See more
Thank you! Those would definitely work in some arrows. I was able to accomplish it with the arrow build and the tip weight.
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top