My new Hori-zone penetrator which is the same bow as a PSE Fang 350 has a cam timing issue which you can feel while shooting. If you look at the pictures you'll see a 2mm difference uncocked, I haven't measured it while cocked yet. When the xbow came, it came in a kit and I had to bolt the limb module onto the barrel myself so unbolting it wouldn't void warranty if I send the module back under a warranty issue.
However, when I had vertical compound bows I did it myself by partially cocking the bow, placing a screw driver in the spokes, unhitching the offending cable and either winding it clockwise or counter clockwise.
My question is, can I do the same with this xbow? I know it's not a string issue but a cable issue and if I can do it myself it would avoid a hell of a lot of faffing about. I'd need a comprehensive guide to help me though.
Thanks.
![186714]( "186714")
![186715]( "186715")
However, when I had vertical compound bows I did it myself by partially cocking the bow, placing a screw driver in the spokes, unhitching the offending cable and either winding it clockwise or counter clockwise.
My question is, can I do the same with this xbow? I know it's not a string issue but a cable issue and if I can do it myself it would avoid a hell of a lot of faffing about. I'd need a comprehensive guide to help me though.
Thanks.
