Hey guys and gals. I have a Barnett whitetail hunter crossbow I purchased 4 years ago. I use it primarily for hunting whitetail. I sighted it in this year as I do every year and my bolts were all over the place. I actually bottomed out the windage to get it on target. When I finally did get it zeroed I went to deer camp. Being a little careful I pulled out the bow to be sure I was still zeroed. It was the exact inverse poi of where I was the day before.
I went through the same process as the day before and again there were bolts everywhere. I changed scope from the utg to a truglo I had. Again, to know avail. I do not know if it is scope or could it be the crossbow. I have never had this issue before and we all know hunting season is here.
Could it be the scope base on the crossbow? Any help would be greatly appreciated. Also, looking for a good backup crossbow. Thanks again!
I went through the same process as the day before and again there were bolts everywhere. I changed scope from the utg to a truglo I had. Again, to know avail. I do not know if it is scope or could it be the crossbow. I have never had this issue before and we all know hunting season is here.
Could it be the scope base on the crossbow? Any help would be greatly appreciated. Also, looking for a good backup crossbow. Thanks again!
