Be careful fellas! Was shooting these yesterday sighting in my new Sirius arrows so I could hunt this cold front and had a wild arrow and this is what I seen at the target! Brand new with about 20 shots on that arrow! It peeled the almost non existent ledge that the arrow seats against and pressed it in perfectly and the string made a little contact to the arrow rendering it useless, I continued shooting with the factory knocks and then serving broke. Serving was already frayed but this sent it over the edge in a few more shots! Now I need to have my serving fixed and I'm going to miss my date with buster ( big 3 yr old 155-10 point)on this cold front!
TroyBrake
Pictures?
From what I'm reading, sounds like the nock insert was just slightly, too small for the arrow shaft. (??) Did you glue-in the nock insert? Also, by chance, was the back end of the arrow cracked? Just trying to understand what the issue is/was.
From what I'm reading, sounds like the nock insert was just slightly, too small for the arrow shaft. (??) Did you glue-in the nock insert? Also, by chance, was the back end of the arrow cracked? Just trying to understand what the issue is/was.
Were you using the .300 ID nocks or the ones that require a nock insert? The Deepower .300 press fit are what you need. They shoot great out of my Swat X1.
If you were using the ones requiring the insert that is the problem they will do that. To much force with a xbow. Never heard of the one piece doing that but I suppose anything is possible that is why I try to check mine before every shot regardless of nock brand.
Sorry to hear of your issue but if you will PM some GPS numbers, I will take care of the 10 pt so no one else gets him. No charge for this service either.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
